Allied Telesis AT-MMC200/LC-960 Media Converter, 100Base-TX to 100Base-FX, 100 Mbps, LC, 1310 nm, 2 km, PoE, Grey

Allied Telesis AT-MMC200/LC-960 – Extend Fast Ethernet over fibre

The Allied Telesis AT-MMC200/LC-960 suits network installations that need to connect copper Ethernet equipment over a fibre link. It converts 100Base-TX to 100Base-FX and supports distances of up to 2 km.

Key connection details

Extend a link across fibre

Use this converter to bridge a 100Base-TX Ethernet connection to a 100Base-FX fibre connection. The 1310 nm wavelength supports links up to 2 km, making it useful where copper cabling alone does not reach between network points.

The RJ-45 interface supports 10 and 100 Mbps Ethernet rates. Auto MDI/MDI-X helps simplify copper connections, while full-duplex operation supports simultaneous sending and receiving.

Keep network traffic compatible

VLAN support follows IEEE 802.1Q, and jumbo frames are supported. This helps the converter work with networks using VLAN-tagged or larger Ethernet frames. Store-and-forward operation checks frames before forwarding them.

Activity and link LEDs help you check the connection status during setup and troubleshooting.

Compact, low-power installation

The grey unit measures 56 mm wide, 101.6 mm deep and 21.8 mm high. It weighs 170 g and uses 1.7 W typically, so it can fit into space-conscious network setups.

It operates at temperatures from 0°C to 50°C and supports operating humidity from 5% to 95%.

Check your network fit

• Confirm your copper equipment uses a 100Base-TX RJ-45 connection.
• Check that your fibre link uses an LC connector and 100Base-FX.
• Confirm the fibre run is no longer than 2 km and uses a 1310 nm link.
• Check that your installation has a 12 V power input available.

Frequently Asked Questions

Q: What does the AT-MMC200/LC-960 convert?

A: It converts a 100Base-TX copper Ethernet connection to 100Base-FX fibre.

Q: What is its maximum transfer distance?

A: It supports a maximum transfer distance of 2 km at a wavelength of 1310 nm.

Q: Which fibre connector does it use?

A: It uses an LC fibre connector.

Q: Does it support VLANs and jumbo frames?

A: Yes. It supports IEEE 802.1Q VLANs and jumbo frames.

A practical choice for 100 Mbps fibre links

Choose the Allied Telesis AT-MMC200/LC-960 when you need to extend a 100 Mbps Ethernet connection over LC fibre for up to 2 km. Its compact size, low typical power consumption and VLAN support suit straightforward network extension tasks.