ATEN AP206 2-Channel DSP Class-D Power Amplifier, 2 x 60W, 4 Ohm, 70/100V Line

ATEN AP206 – efficient two-channel sound reinforcement

The ATEN AP206 suits public address and other audio installations that need two-channel amplification with flexible speaker support. Its Class-D design delivers 2 x 60W while keeping power use efficient.

Key specifications at a glance

Tune the sound for each space

The built-in DSP gives installers practical tools to tune a sound system. Use the five-band Speaker EQ, delay and limiter to shape output and help protect connected speakers. You can save up to 20 presets for different settings.

Configuration takes place through the WebGUI. Also, ground lift helps address unwanted hum from the power circuit.

Choose a suitable speaker setup

The AP206 supports 4-ohm low-impedance speakers, as well as 70/100V line systems in Bridge mode. This flexibility makes it suitable for a range of public address applications.

Balanced and unbalanced line-level inputs support different audio system arrangements. Check your speaker type and amplifier configuration before installation.

Quiet operation with built-in protection

The fanless design avoids fan noise and helps prevent dust building up inside the chassis. Class-D amplification and ENERGY STAR qualification support efficient operation.

Protection features cover shorted outputs, over- and under-voltage, high-frequency overload and overtemperature. The amplifier mutes if the heat sink exceeds its temperature limit. Customisable Auto Standby can also put the unit to sleep when the signal stays below its selected threshold.

Check your installation requirements

• Confirm your speakers suit 4-ohm low-impedance operation or 70/100V line operation in Bridge mode.
• Check whether your system uses balanced or unbalanced line-level inputs.
• Confirm whether your installation requires RS-232 or Ethernet control.
• Check whether you need the AP901 Dante or AP902 Mic/Line Pre-AMP expansion card.

Frequently Asked Questions

Q: How much output power does the ATEN AP206 provide?

A: It provides 60W per channel across two channels.

Q: Can it drive 70V or 100V line speakers?

A: Yes. It supports 70/100V line loudspeaker systems in Bridge mode.

Q: How do I configure the DSP?

A: Configure it through the WebGUI, with Speaker EQ, delay, limiter and up to 20 presets.

Q: Can I add Dante or microphone inputs?

A: The expansion slot supports an AP901 2-CH Dante card or an AP902 2-CH Mic/Line Pre-AMP card.

A practical choice for flexible installations

Choose the ATEN AP206 when you need efficient two-channel amplification, DSP tuning and support for different speaker systems. It is a strong fit for installations that also benefit from quiet, fanless operation and remote system control.